Can we manually synchronize two DG sets of same ratings
manually without using speed biasing ? If yes then how?
Answer Posted / k.prakashchandra
You can use dark or bright lamp method synchronizing .But,
speed control is required.
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
what is the value of combined earthing in general electrical circiut?
why impudance relay used for medium transmission power system? why not others?
What is evaporator & condencer & compressor
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
please tell me how a surge protector work on a DC 48Volt.? please describe briefly.
state basic meaning of 'INDUSTIAL AUTOMATION'?
How to run a three phase motor into single phase........
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
how the works electronic energy meter?
How dia computation perfomed in cold rolling mills .
What the difference between ac and dc inductor an capacitor
What is phase cross over frequency?
Why 15Amp. MCB is suitable to carry load of 1.5Ton Ac please Explain?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
thyristor controlled APFC panel design parameter?