How transformer neutralshould earthed ? Transformer neutral
connected to earth mat in substations, right or wrong ?
Answer Posted / munna
Transformer neutral should be earthed separately by Cu Flat
strip to Earth Pit. Yes T/F neutral is connected to earth
mat in substations.
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
Benifits of 3ph 4 wire metering over 3ph 3 wire
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
brief notes on ammeters
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
what happen when we add mentos in cold drink?& why?
Is there any abbrevation for STUB in Stub bus protection
what is the advantage of connecting capacitors in delta than in star?
how pt is using
how to check regenerative load in drived motor
how to calculation increase power factor for single phase
what are the interview question asked in wind mill about electrical
Name one of major transformer company in KSA ?
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?