Three way plug point is there ,in that plug why we need
earth pin is bigger than compare with phase and nutral pins?
Answer Posted / dhivyabharathi
The earth pin has to send fault current to earth.so, the
resistance of that path should be low.to get low resitance,
cross sectional area should be more. it can be understood
from R=pl/A.so the cross sectional area of tat pin should be
high.
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...
please send me the L&T Emb. sys. placement papers and entire details of pattren
how to calculate compresor capacity?
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
what is meant by re-rolling motor? how it differs from standard motor?
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
How to select transmission line type (i.e. 11kv or 33kv) for new established industries
Is it true online ups having bypass mode if it is true then why we called ups because it is interrupting power when goes in bypass mode
what exactly commisioning work does in electrical site work... LT side?..
plz send me the syllabus or any sample paper for engineer trainee recruitment if any,on ravinder911@yahoo.com
What is pd controller?
A motor running with lenze frequiency inverter stops if I REDUCE SPEED with 25% load.If I run it in High speed and medium speed running smoothly with full load.please help me to solve it.
WHAT IS START TO INDUCTION MOTER IN STAR TO DELTA OF >5HP ?