What is the basic difference between the electrical
engineering and electronic engineering?
Answer Posted / mayur
electrical engineering is that it is use for high (big)
amount of parament like 100 volt, 10.000v .......Megawatt
etc....at that the current value , voltage value and
another effected value can be very very big or high compare
to electronics eng..
Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
how can i apilly for electrical c licencese.sir,i completed B.Tech in electrical & electronics engineering in 201onot working any company
wHAT IS CAPACITANCE LATCHING? hOW TO CALCULATE CAPACITANCE LATCHING? hOW TO SOLVE THE PROBLEM IF CAPACITANCE LATCHING APPLIED?
when 20hp 3 phase motor start no load condition in star or delta connection.find current and write formula.(tariq)
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
i have interview in Pepsi company what type of question will ask please send the question and answeer
What is the working principle of CFL & T5 tube light & 40W tube light with electronic ballast?
How much of the total hydro power potential has been exploited so far in india?
How to calculate the efficiency of Turbo Generator(Alternator) in general....?
why dimmerstate always connected in star connection? what will happen if it connected in delta?
plz tell me,ht and lt panel terminals in substations explain beiefly
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
battery capacity use of made?
i need to now what will be the cable size to the following load, transformer to distribution panel distance 110m, load 1000kw, voltage 400v, pf 0.85, permissible voltage drop 2.0%, overhead line, atmospheric temperature 35 degree c.
what is meant by poly phase induction motor ? how its operating by single phase or three phase?