why fuse amperes rating are specified ratings like 32amp &
64 amps?
Answer Posted / srikanth
current is flowing in fuse.. current is measured in amps
therefore fuse is measured in amps.. it is depent upon the
current rating.. current increases rating also increases...
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
which pump used in STP
why the arc welding machines require parallel earthing systems? ie why each machines are connected to earth pit by separate wires during earthing? wats it adavantages?
what is the difference between droop mode and ischnorous mode in thermal powerplant?
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
wish of these transformer uses oil?
Why is the air gap between the pole pieces and the armature kept very small?
What happens when ac supply is given as excitation voltage instead of dc supply
can we synchronize star system generators with delta system transmission line ? and how ?
What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.
What are all present producing cost of Per KWH of various Fuel?
What is meant by analogous system?
what is the difference between an alternator and a synchronous motor
why do we not use equivalent voltage source in negative sequence equivalent ckt.
HOW TO WRITE A QUENTION ANSWER? I MEAN SHORT OR LENGHTHY ? OR FROM THE BOOK AS BOOK..... SOME TIME WE GIVE A ANS FROM THE BOOK AS LIKE BOOK ND WE GET MINIMUM 60% MARKS OR MORE THEN....... THEN HOW TO FILL THE Q-PAPER?