Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference b/w HT & LT and the range of HT & LT ?
- 22 Answers
- 65610 Views
- AF, Schneider, I also Faced
- E-Mail Answers
Answer Posted / md. obaydur rahman
Having a high voltage, or designed to work at or sustain
high voltages. High-tension(HT) wires used to carry
electrical power over long distances sustain voltages over
200,000 volts and if the voltages are lower then called low
tension(LT).
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
what are all types of cross section in AC cables?
what is protection class current transformer.
how much leakage current is allowed in MC61A L&T make relay?
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
Explain thin film resistors and wire-wound resistors
How i can decide that HVDC line is best for transmission.
TRAFO 1. WHY BREATHER IS USED. 2. WHY OIL GOES DOWN IN CONSERVATOR TANK. 3. WHY WE ARE TAKING OIL SAMPLE TAKING FROM BOTTOM OF TRANSFORMER. 4. HOW TO CHECK IR VALUE OF TRANSFORMER. 5. WHY OLTC HAVING BUCHHOLZ TRIP ONLY; WHY NO ALARM. 6. OFF LOAD TAP CHANGER OPERATION PROCEDURE. 7. TR. SHUTDOWN / ISOLATION PROCEDURE. 8. WHEN THREE TRS. IN PARALLEL, ONE TR. IS NOT SHARING THE LOAD – WHAT IS REASON AND WHAT YOU WILL DO. 9. WHY TR. HAS OLTC IN HV SIDE. 10. WHAT IS % IMPEDANCE. 11. WHY TR. RATING IN MVA. 12. WHAT IS VECTOR GROUP IN TR. 13. CONDITION FOR PARALLEL OPERATION OF TRS. 14. WHAT IS TERTIARY WINDING. WHERE IT WILL BE. 15. IF TR. TRIP ON BUCHHOLZ OR TAP CHANGER RELAY, WHAT YOU WILL DO. 16. DIFFERENCE BETWEEN OIL TEMP. AND WINDING TEMP. PROTECTION 17. HOW WINDING TEMP. IS MEASURED IN CAST RESIN TR. 18. DIFFERENT TYPES OF FAULTS IN TR. Trafo - Page-1 of 2 19. WHAT HAPPENS WHEN TR. CHARGED FROM LV. 20. WHAT WILL YOU DO IF MEGGER READING SHOWS ZERO BETWEEN LV WINDING AND EARTH. 21. CAN WE INTERCHANGE BUCHHOLZ RELAY OF MAIN TANK AND OLTC TANK. 22. IF THE LINE BETWEEN BREATHER AND CONSERVATOR TANK 23. LOCKED, WHAT WILL HAPPEN DURING LOAD CYCLE. 24. WHAT IS THE FUNCTION OF OIL SEAL IN BREATHER. 25. WHAT ARE LOCATIONS FOR BUCHHOLZ RELAY FIXED IN POWER TR. 26. WHAT ARE CHECKS IN POWER TR. DURING MAINTENANCE. 27. WHAT IS IMPORTANT WHEN WE CHECK OLTC OPERATION DURING MAINTENANCE. Trafo - Page 2 of 2
How to calculate impedance volt in Transformer?
What is Auto Mains Failure Panel & Auto Synchronizing Panel
what is the use of the puls transformer in UPS & how it works???????????
What are the various types of BUSBAR Schemes? explain each
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
When will you multiply and devide with derating factors to the actual value while sizing the cable?
