Why not cars which have a wheel type steering, requiring
many rotations to be made to turn the car, be replaced with
a handle type steering, like the one provided in a
autorick shaw for quicker turn?
Answer Posted / naveen
Auto has only a single tyre and it can be turned through a handle type steering whereas Cars, buses and other four wheelers its impossible to turn two front wheels with a handle type steering, it can turned only with wheel type steering as it can control two front wheels
Is This Answer Correct ? | 9 Yes | 6 No |
Post New Answer View All Answers
What size of a compressor (cfm) is recommended for the purpose of inflating car tyres, spray painting, etc.?
What do you understand by Newtonian Fluid? Where is it used?
can we use servomotor for applying torque or load to the gear box drive shaft at various speeds for gear box testing purpose
What are three methods of heat trfer?
What is the basic difference between honing and boring.
What are three methods of heat transfer?
What is back compressor in engines?
What is the allowable -ve crankcase pressure (vacuum) in the gas engine of 1.5 mw?
Is boiler a closed system?
What happens if gasoline is used in a Diesel engine?
What is bearing and what are the different types of bearing ?
What is standard size journal and big end crankshaft in mahindra bolero
Mean effective radius of contact surfaces of a clutch plate is decided by a) Coefficient of friction b) Axial pressure c) Space available in the vehicle d) Amount of torque to be transmitted
Hi guys! I buyed this clone carprog but i realized that not reading 24cxx. I tried 93cxx and 25cxx and it read.But 24cxx not.I tried to put external power.Of course the eeprom was soldered out.The interface is new and never read 24cxx.I tried many 24cxx .Is there a solution for this problem? I read in other forum that need to replaced 74hc125D with 74hc125M 4 pieces. thanks!
Describe Hooke's Coupling and its uses.