why the CT ratio secondary is always divided by 5 for eg(
75/5,80/5,50/5)
Answer Posted / k.prakashchandra
Secondary 5 A was used earlier.Now with electronic relays
and meters ,the secondary is 1 A
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is ic 01,ic 06 ?is it types of cooling?
What is negative sequence over voltage element?
Hello everyone, somebody knows what is a "surplice power" ? The hole phrase is: "This rating is appropriate for a generator set paralleled with an infinite bus e.g. a national electrical supply network or grid where the generator set is run at 100% load, 24 hours a day, 365 days a year and any surplice power is exported into the grid" Thanks in advance.
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
how we select ac fuse rating of an power inverter???
How to calculate capacitor bank value to maintain unity power factor with some suitable example?
What is the disadvantage in proportional controller?
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
What is the need for a controller?
completed BE & done apprentice at tneb & having experience 6 years. want to get c license. will apprentiship & BE be helpful for getting c license. will i get any preference by showing this?
When and where resistance earthing is used ? How to calculate the time constant for earth fault
how ceiling fan worked?
What is proportional controller?
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
how we can do the insulation on secondary of ct explain and so that tan delta will within limit