Answer Posted / k.prakashchandra
Fully charge the battery first. Then discharge till the
voltage drops to 90% and calculate Amps X hours.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How much no load current of synchronous motor
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
Define resonant peak?
as a electrical student why should i hire you?
HOW WORK HEAT PLATE EXCHANGER
What is the difference between alternator and generator?
What are the characteristics of negative feedback?
in dc series motor if field wdg is shorted then
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
I have iti elec, 1st aid, and 5 yrs experience in 7.5 mw power plant. Am i eligeble for 11kv license in telangana state..when, how to apply for that.?
WRITEDOWN FEW RELY CODES
How to decide the size of the capacitor for a single phase induction motor say 2 HP ??
how to control the speed to switched reluctance motor
What is difference between safe PLC and normal PLC
What are the types of feedback oscillators?