I have 2 KW electric water heater.I am gonna use it in
controlling water temp.so I needed to increase or decrease
the heating capacity.is there any electrical-electronic
circuit for varying the resistance & so current?
- 1 Answers
- 2589 Views
- I also Faced
- E-Mail Answers
Answer Posted / mallikarjun
If you use AC voltage controller of required current rating
(Variable)it is possible. An example for such is a Fan
regulator (Electronic).
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How you give clearance to a spare feeder.
What should be the protection scheme for a 15kw, 3-phase motor working in a lathe machine.
What is transformation ratio what it describes?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
How does a transformer contribute towards the widespread popularity of ac system over dc?
how to calulate short circuit current for the following: 1.cable connecting 11KV of 22KV/11KV transformer to 11Kv of 11KV/415V transformer 2.what cable size should i use.
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
ITI r/tv trade APPLY (J.T.O VACANCEY) ALSO INCLUD AITT ELECTRONIC,WRITEEN XAM DONE 23.03.10 BUT NO RESPONCE WHY ANATHER ID gopal_gh007@rediffmail.com
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.
What is the armature mmf in a D.C machine?
can u describe the method used for protection of transmission line.
If more than rated DC voltage appears across trip coil of the breaker, what will happen? e.g. in 110V DC circuit system, if voltage across battery terminal showing 121 V
what is deffrence between squirral cage and wound rotor in IM?
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
What is the permissible maximum flux density in transformer core?
