which motor is used in electric train...???????
- 27 Answers
- 54001 Views
- ESPL, IOCL, I also Faced
- E-Mail Answers
Answer Posted / jeykishan kumar.k
its an obvious answer: DC SERIES MOTOR
reason:- In trains there are many comartments full of
passengers,so during the starting it requires high starting
torque and in dc series motor torque T proportional to Ia
square and Ia=If,so if the motor started without any load
then the armature current will be very high which may
damage the motor.
| Is This Answer Correct ? | 6 Yes | 4 No |
Post New Answer View All Answers
we are having 15kw and 3kw motor both can run in same time , instead of using copper we are using ug aluminium cable , 35 sq.mm is suitable for its current carrying capacity..?
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
The size and construction of bushings in a transformer depend upon?
how to ctrl motor by use of ac or dc drive.plz explain evdintly
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
What are the commonly used schemes for the bus zone protection?
why US countries maintains 110v and 60HZ
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
Why the power generated in dams is complex power? Why the generators in dams cannot produce Real power directly (i.e power which has zero reactive part)?
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
how can get electrical "c" licence.i am complited in DEEE.PASSING YEAR OF 1993.WORKING IN PVT COCERN LT LINE.PLEASE ADVISE ME .CELL NO 9994786021
As we use capacitior bank in 3ph ckt for improvement of PF, why not we use capacitor in single phase domestric use, at our house their are many inductive equipments,like fan,mixer,tube choke,air conditioner they also draw PF... by using capacitor can they improve PF. if yes--what are advantage and how to connect a capactor in single ph,and which type of capacitor if no- what are disadvantages.
What are the different types of controllers?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
Can I use star delta connected induction motor for dual supply voltage?
