why sielent pole is used only in hydro generators and not in
turbo generators
- 1 Answers
- 3346 Views
- I also Faced
- E-Mail Answers
Answer Posted / kamaleswaran
its well known tat der r 2 types of syn m/c..dey r salient pole and cylindrical... v kno tat speed s indirectly proportional to no. of poles..(N=120f/P)..Hydro gtr needs low speed operation.. salient pole has many poles which reduces it speed n its used fr hydro gtr and turbo gtr needs to b operated at high speed.. so cylindrical s used..
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
how to calculate compresor capacity?
what is basic difference betmeen normal & flame proof motor??
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
when 20hp 3 phase motor start no load condition in star or delta connection.find current and write formula.(tariq)
During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
why and where we use early make & late break contacts in protection?
Differentiate between induced emf and self inductance?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
Write the force balance equation of m ideal mass element.
Differentiate between voltage and current feedback in amplifiers?
how to calculate vfd o/p voltage by frequency
What is block diagram?
