if a tank is contaning oil and water than how can we
measure the oil and water level seperately
Answer Posted / tarique r
dear friends i have very simple answer just use conductivity
type level tansmitter so can measure water level as rest of
you can see as oil level because of non conductivity
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
I want to know about DDCMIS in detail ? please explain it. Also give name of reference books in which it is explained in detail in very simple manner.
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
What is force balance principle?
Who to difference between analog in & analog out in dcs?
what is the difference between -24 : +24 & 0:24 and where it use?
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
what is loop1 and loop2 in MTS LT?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
why we r opening HOT BYPASS valve during startup of a compressor?
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
what is the current pay package for an instrumentation engineer having 2 years of experience in cryogenic technology???????
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
What is limitation of the ht.of the displacer of a level trol?