WHAT IS OLTC OF TRANSFORMER? WHERE IS ITS USED EITHER ON
PRIMARY OR SECONDARY SIDE OF TRANSFORMER?
- 2 Answers
- 5357 Views
- I also Faced
- E-Mail Answers
Answer Posted / mayank
OLTC means...ON LOAD TAP CHANGER. It is provided on the HV
side of the transformer. On HV side as the current is less
we can easily( not that easily..) switch over to different
voltage levels thus producing minimum chances of arc
production. While on the LV side as the current is very
large On load tap changing almost becomes impossible.
| Is This Answer Correct ? | 15 Yes | 2 No |
Post New Answer View All Answers
which type of amplifiers are used in multimete?
PLZ EXPLAIN CORONA,SKIN,BIRD PALE,SPAN,SAG Effects of power cable.
what is servo motor and how it works?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
why we are using Load factor?
Safety of dry type transformer
How generating electric power export to grid from the generating station ?
What is the actual calculation for transformer short circuit test?.
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
how can i determine the KVA/MVA rating of transformer precisely?? is there any standard test?????
battery capacity use of made?
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
what are all the components required to assemble solar panel other than pv cell?
