Answer Posted / thanigaivel
p=v*icos@
i=p/v
p=power-watts
v=voltage-volts
i=current-amps
cos@-power factor
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
how was your last weekend.
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
placement paper samples of mspl company
How I can Compare 120v/60Hz versus 220v/50Hz ? Please tell me both advantage and disadvantage ......
sir please send me iocl written test paper in my e-mail account. i'll be obliged to you........ thank u roshan
How to calculate the sag on transmission Lines.
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
What is the magnetic field (coil DC ) of Turbo Expander?
What was your role in the silicon evaluation/product ramp? What tools did you use?
What types of high speed CMOS circuits have you designed?
sir, I am from EEE branch.On feb 17 iam going to write an Exam for hindustan petrolium corporation Ltd.So plz send me the written exam pattern/Q's/interview questions.please mail to eee_dharmendra@yahoo.com
Electrical Engineering
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
