Answer Posted / mithilesh kumar
DCS ARCHITECHTURE IS RELATED WITH "FIELD CONTROL STATION"
(FCS) AND HUMAN INTERFACE SYSTEM(HIS).
FIELD SIGNAL FOR EG.(DI,DO,AI,AO) IS CONNECTED WITH FCS
PANEL AND IN FCS USED NEST,VLNET,VNET, DEPEND UPON TYPES ON
DCS.
HIS IS CONNECTED WITH EHERNET.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
How to work temperature gauge?
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
Draw bode plot of any transfer function. Why is plotting bode necessary?
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
what is the responsibility of an instrument commissioning supervisor
What are primary elements of measuring pressure?
What are the types of control valves available
How to calibrate H2s Dectector
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
what is interface level and how it is calibrate?
Can anyone convert a 5/2 way or 3/2 way valve into an ISO valve?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....