Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference between AC VVVF drive & Dc VVVF drive
explain their working principle?
- 13 Answers
- 48483 Views
- Apollo, OPS, I also Faced
- E-Mail Answers
Answer Posted / rawat
In AC VVVF drive we control the motor by changing its
frequency through drive. But in case of Dc drive there is
armature voltage and field voltage which are controlled by
scr's.
So there is no frequeny in case of dc drive as here dc is
not changing into ac.
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
sir plz send some previous year questions of jspl.
what is the ATS .And how it works.
Dear friends, i would like to know that what is the exact function of 'exciter winding' & 'aux winding' in Alternator?
WTA used cb?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
whatare the disadvantages occur,if the form factor of transmission will not be equal to 1.11
How a band pass filter is constructed?
1. What is maximum permissible distance between smoke detectors ? 2. How do we decide number of smoke detectors required in a large office, warehouse, hall etc ? 3. What should be maximum height of smoke detectors ? 4. Where do we use heat detector, optical smoke detector, temperature sensitive detector ?
how to check regenerative load in drived motor
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
Define non-touching loop.
what is Different between Bilinear and Unilenier?
How phase displacement change in the over current relay coils.
what is Fan Control Cubicle
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
