when we increase load , current drawn from source also
increases why ?
Answer Posted / raul
when we increase the load, the speed and hence the voltage
decreases and thereby flux also decreases, to maintain d
flux at a constant value, more current is drawn from d
source............
Is This Answer Correct ? | 8 Yes | 7 No |
Post New Answer View All Answers
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
A well system is when , no. of bus bar is less or more. Tell me the concept of it.
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
How to measure the earth resistance value in a concrete pavement(flood light area)?
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
What products have you designed which have entered high volume production?
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
1.Z transform always lies around ? a) origin b) pole c) zero d) z=1. Multiples Mcqs which is bother me can’t find answers on internet. Some help required with little explanation . Note: this is not homework or related to any test. Thanks
What are the weight of 800KV DA,DB and DC type tower ?
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
How to convert a two phase power into a three phase power in induction machine?
What are the advantages and disadvantages of the dc motors?
How is the gain affected by the introduction of feedback in a control system.
what is the difference between the voltage of 5 volts capacitor and and 5volts battery?