Interested to Buy Any Domain ? << Click Here >> for more details...
why the no.of slots in stator in not equal to the no. of
stator in rotor in induction motor????
- 4 Answers
- 21274 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / raul
yes the exact term is COGGING....which means if the stator
poles and rotor poles are equal or in integral ratio, then
there is a strong alignment b/w the stator n rotor poles
and hence the alignment torque is greater than the starting
torque.....so magnetic locking takes place b/w the stator n
rotor teeth........
| Is This Answer Correct ? | 13 Yes | 1 No |
Post New Answer View All Answers
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
State angle criterion.
what is your aim
What must be the minimum distance maintained between 2 Generators as per International standards?
what is a reactive power? what is the relation with power factor?
grr resistance & contrator malt continuous
Work done in a free expansion process is
State kirchoff current law?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
WHY L-G FAULT IS MORE SEVERE IN TERMS OF RRRV?
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
how to select size of hardware for linking aluminium busbar is it depend on area of busbar or current flowing through bus bar
Define de-sensitivity?
Mention what are the types of semi-conductors?
