Interested to Buy Any Domain ? << Click Here >> for more details...
why we use carbon brush in exciter&genrator?
- 5 Answers
- 11963 Views
- ABB, SMC, I also Faced
- E-Mail Answers
Answer Posted / raul
brushes r the means of supplying the direct current from
the commutator to the external load ........n the contact
resistance is an important factor which plays an important
role. in dc generators, carbon brushes also helps in
improving commutation
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Can clean earth cable be considered as low current cable
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
what are the necessary basic electrical topics to learn for mechanical engineer to deal practical problems.
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
When lag/lead/lag-lead compensation is employed?
How to calculate phase to phase difference ?
what type of motor used to move a 1 ton gate? and relate ratings with load.
100 MVA 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase. what will be the fault MVA of generator.
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
What is dc current source?
What is the function of NER and NET?
how to get bearing & winding temperature of an induction motor?
how to calculate units consumption for a 12 hp motor /hr.
