Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ponnu(the elite)
oil,water,air.most of all we r using oil
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
how to measure the transformer resistance values(dyn11)?and howmuch the minimum value?
what is the relative size of single and three phase?
what is ratio of copper wire size and current ?
Why need 3phase machine double earthing?
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
WTA used cb?
What is superposition theorem?
Explain the iniluencc of short circuit ratio on the pert'orniancc of synchronous machine.
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
how to select rating of HT Panel
Define the term Capacitance and Inductance?
what is capacitor voltage transformer?? how it is different from potential transformer?
How many types of electric motors are there?
what is earth resistance? how to measured? and give values at power station and mcc area?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
