what is the difference between electrical & electronics
- 245 Answers
- 302119 Views
- Axon Constructions, Banking, GDA Technologies, Infosys, MBA, Satyam, Satyam Tech, Snow White, TCS, I also Faced
- E-Mail Answers
Answer Posted / khanzada cecosian
a short answer is that electrical deal with conductor and
elctronics deal with semiconductop
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
what is basic difference betmeen normal & flame proof motor??
how calculated Transformer losses.
why we need to us lenz's law for synchornous motor
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
why we testing the core balance of the transformer before comissioning?
How it can worked plc based electrical system And which type of software using.
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).
what is invertor supply and raw powersupply
how to carried out tan delta test in 11 KV alternator ?
DIFFERENCE BETWEEN NORMAL TRAFO AND THRISTER TRAFO?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
Why it is necessary to isolate fire fighting when you are taking shutdown for lv board.
