Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / prajee
-184.44 to 648.88 degree centigrade
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
in valve is constructed as per SME B 16.34, then which standard is used for fire testing of valve?.
Definition of reverse and acting controllers:
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
can u briefly explain aboutan aryton shunt multirange DC ammeter?
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
Tr. Wiring for calibration.
what is the difference between attemperator and desuperheater ?
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
can you send remote seal interface level transmitter calculation steps for oil water saperator.
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
Valve positioner and actuators in detail.
