Answer Posted / t.chandrasekar
the bending moment coming over the beam is of two type viz.
hoggging and sagging.when reinfircement rods are provided
in a beam the rods can be provided at the bottom where
there will be sagging moment and at the point of change
from sagging to hogging the rods will be cranked towards
top to withstand the hogging moment
Is This Answer Correct ? | 52 Yes | 5 No |
Post New Answer View All Answers
asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream
What is the strength of 1:6:12 mix?
How much quantity of rod binding work by a rod binder per day
who to find building iron rod strenth
what is right & short method of measurement of slab&beam
What ingredients with% found in ppc cement??
Why is concrete cube test carried out?
How to do base isolation for RC framed structure using ETABS software?
what is the water-cement ratio of mix design while 30mpa in 7 days?
Design a reinforced concrete combined footing (rectangular) for two columns located 3.60 metres apart. The overall sizes of the columns are 40cm x 40cm and 69cm x 60cm and the loads on them are 1000 kn and 1500 kn respectively. The space available for the width of the footing is restricted to 180cm. The S.B.C. of the soil is 280 kn/mm2 use M15 concrete.
WAP to print 1) 1 1 1 1 1 1 1 1 1 1 2) 1 2 3 4 5 6 7 8 9 10
what is idealized curve for concrere and steel
What is componsation
what are the types of design? which type of method is used at what type of design & why?
what is BPM in concrete demolition hammers. what is better a higher value or lower