What is principal to reduce earth leakage current with
isolation transformer? When isolation transformer is
installed in input stage of system, earth leakage current
is reduced. the reason is why the leakage current of 2nd
stage of isolation transformer does not affect the 1st
stage's leakage current. I would like to know the reason.
As you know, earth leakage current is a kind of AC. So, How
to reduce earth leakage current in case that isolation
transformer is used?
- 2 Answers
- 9408 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
If the neutral of secondary is not earthed ,the phases of
secondary lose the reference to earth ,but slightly for
capacitive coupling. After the second stage ,the earth is
almost completely isolated.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to calculate singlephase motor efficiency?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
how to calculate the loss tangent of electrical cables
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
If not into production, how far did you follow the design and why did not you see it into production?
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
What are the ratings of VCB, MCB, MCCB, SF6, ACB, and OCB?
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
What do you mean by a current transformer?
why are u join ntpc
What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?
Define corner frequency?
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
