Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jazz
4-20 mA signal differentiates live process 0% with 4mA
signal with a wire break (0 mA), current is also used for
transmission because even if your receiver or PLC/DCS card
is far away current signal sent proportionately by the
transmitter will be received as the same current at the
receiver/PLC/DCS card, although it is converted as a voltage
signal (1 to 5 VDC) by a 250ohm resistor, since
micro-processor process signals in voltage levels.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
applications of plc in printing and packaging?
what is the calibration procedure for transweigh make weigh feeder?
NSV type probe stands for
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
Tr. Wiring for calibration.
What is the purpose of LO Overhead tank in turbines.
draw the block diagram of a level transmitter ?
give me all the details about the interview and which type of question being asked
Is there any relation between Artificial Intelligence and Instrumentation?
steps for installing orifice plate?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
what is vibration a part of proceess variable? if vibration is a part variables then how we minimize the actual vibration on machine on load,? vision of instrumentation contrl plz ans me IPGDL interview question
What is the meaning of wet leg
Why plc require in analog input 4-20amp & 0-10 volt?
