IN THERMAL POWER PLANT WHY WE ARE USING SINGLE SHAFT FOR
THE COUPLING OF HP,IP&LOW PRESSURE TURBINES....WE CAN USE
INDIVIDUAL SHAFT FOR EACH TURBINE....?
Answer Posted / pradeep patel
according to me it can be very easily understood by an
example of multi cylinder i.c. engine in which output of
all of the cylinders is transferred to only 1 shaft.if
power is transfered to only 1 shaft the output can be
controlled very easily by using only 1 gear box & other
supporting arrangement. the another benifites are lower
initial cost & compactness of mechanism.
Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What do you mean by cotter joint?
Why can't we use antifrictional bearing in place of journal bearing in a 660mw plant
How much calorific value of heat is needed to heat 00c of
Define tons of refrigeration and cop.
DIFFERENCE BETWEEN CODES,STANDARDS & SPECIFIFCATIONS?
What are the causes of low compression in the main engine?
which tests are performed in central air conditioning
What is difference between conjugate beam and continuous beam ?
How do you control cylinder liner wear?
What is the difference between newtonian and non-newtonian fluids?
ball pen is writtingg on paper
What is the difference between EN 8 and SS410 grade material with chemical composition and application.
draw neat sketch of pirani gauge with wheatstone bridge circuit to measure output. discuss its construction working princple
What are steam turbine parts usually come into damage?
Define isometric drawing?