Interested to Buy Any Domain ? << Click Here >> for more details...
i feel sq. pipe is better than round pipe pls give comment
for this.
advance thanks for reply
- 3 Answers
- 5641 Views
- I also Faced
- E-Mail Answers
Answer Posted / jazz
pipes are round since pressure is exerted equally in all
directions, all pressure points are equal. if you have a
square pipe, pressure is exerted more on the 90 deg bend for
a square pipe, so since Pressure=Force/Area , you have a
very small area in the bend Force is greatest where you have
a very small cross-sectional area.That point (bend) becomes
a weak point, and becomes a possible leak point.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to Calibrate Coriolis Flow transmitter in field
In Safe Guarding test what means by "Failed to Danger" ?
How hart protocol can be connected with control valves?
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
i am from instrument branch i want paper patern of mahagenco . any pevious years paper regarding my branch send me please . please.....
PLEASE PROVIDE SAMPLES OF CHEVRON SKILL TESTS
How to Calibrate Flammable gas detector in field
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?
Draw block digram for well head from well to shipping pump?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How to Calibrate Vibration Probe (Axial, Redial) in field
hi! i want to know about mpse exam.
How to Calibrate Interface Level Troll in field
line up procedure for dp type flow transmitter?
