Interested to Buy Any Domain ? << Click Here >> for more details...
Why is DC use instead of AC for protection and control
circuits?
- 4 Answers
- 8968 Views
- I also Faced
- E-Mail Answers
Answer Posted / vijay balu raskar
DC is constant & continuous source. For protection & control it is suitable. Also, having quick responce without disturbance & variation. In ac opposite of dc.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
What is 11 N1 and 12 N2 in single phase Transformer ?
what is through fault?
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
What is touch potential and step potential?
if sf6 gas low in gis what will happen
Difference between RCCB, RCBO and ELMCB.
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
From what on-site components does the HT panel monitoring the bus-bars in a 11kV system take inputs?
How the circuit breaker is selected for Induction motor of 100 kW, 415 volt, 0.85 power factor, 0.95 efficiency ?
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
how is working bearing heater?
what are the types of electromagnetic forces developed in practical transformer?
What was the Dg set radiator and lube oil temperatures trip in ACB
