Interested to Buy Any Domain ? << Click Here >> for more details...
If single phase voltage level is 230V than why three phase
voltage level is not 660V ?, but it is only 440V.
- 16 Answers
- 74448 Views
- BSNL, DOS, EFS, HMT, L&T, TCS, ThyssenKrupp, I also Faced
- E-Mail Answers
Answer Posted / s singh
In single phase case; 220 v is potential difference between phase and neutral, whereas in three phase case potential difference between any two phase terminals will be around 415 v. All three lines show a potential difference of aprox 220 v with respect to neutral but are but are apart from each other by an angle of 120 degree (phase difference) so will exhibit almost double potential difference between any two line terminals. So for all practical purposes potential difference between any two phase terminals will be around 415v. However for power calculations etc we multiply 415 with squareroot of 3 to get actual total line voltage which is a sine function of phase angle between them.
| Is This Answer Correct ? | 53 Yes | 8 No |
Post New Answer View All Answers
i have completed deee and i've (June2012-feb 2015 experience in electrical maintenance in pvt ltd company.company having HT & LT electrical power.how to apply electrical C-license ,NOW I was resigned my job,what are requirements of applying for c-license
why we get 2 differnet values for power factor in 2 watt meter method in 3 phase
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
what is the VA(Volt-amphere)? define with calculation?
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
What is the safety of UPS?
What does the term power factor shows?
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
why Induction Generators are not "Black start" ? and apart from WTGs where this types of generator are generally used?
whether starting current is limited to rated current of motor through soft starting or it exceeds the rated current?
what are the pecularity of shaver sockets ?
what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing
how to check three phase motor torque value?
What is routh hurwitz stability criterion?
how could we calculate the no of outgoings from a 800 watt distribution board
