Interested to Buy Any Domain ? << Click Here >> for more details...
Why r used of cable 50sq.mm and above size cable in 3.5 core. And below size in 4 core ? any technical reason please explain it
- 2 Answers
- 5325 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajiv gupta
3.5 CORE CABLES ARE USED FOR BALANCE LOAD. IN BALANCE LOAD
THERE IS 0 CURRENT OR VERY LESS CURRENT IN NEUTRUAL WIRE.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What is time invariant system?
Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set
can we install HT panel & LT panel side by side or how much clearance is required ?
what you have to see after one week or month from the day of installation of transformer ?
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
Please tell me in DETAIL about the following 3 types of fuses or recommend me a good power system protection book or a website link ? 1.Dropout Fuse 2.Striker Fuse 3.Empulsive fuse (not sure if its impulsive or explosion fuse , sorry)
WHAT IS ELECTRICAL MAINTAINTENCE ?
what is the transformer turn ratio formula and give some examples?
What is an automatic controller?
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
What are IR values and what it should be for coil and for insulator
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
