Why not cars which have a wheel type steering, requiring
many rotations to be made to turn the car, be replaced with
a handle type steering, like the one provided in a
autorick shaw for quicker turn?
- 3 Answers
- 5907 Views
- Ashok Leyland, I also Faced
- E-Mail Answers
Answer Posted / arjun
wheel types steering is used because in slow speed handle r
more efficient to turn the vehicle but
1)in high speed the centre of gravity is shifted from its
point & vehicles balance is poor
2)due to its mechanism it takes more effort to turn the vehicle.
3) tyre life would shorter
| Is This Answer Correct ? | 24 Yes | 1 No |
Post New Answer View All Answers
why pistons rotate in clockwise direction?what are the functions of counter weight in crank?
Does diesel engine powered automobile use unit pump and unit injector?
Discuss the Otto cycle.
How to calculate the speedometer ratio in the vehicle?
The function of the final drive is to a) Provide a permanent speed reduction b) To turn the drive round through 90o c) To provide drive to the rear wheels d) all of the above
Mean effective radius of contact surfaces of a clutch plate is decided by a) Coefficient of friction b) Axial pressure c) Space available in the vehicle d) Amount of torque to be transmitted
Why this technology is used in motor bikes?
What is the range of engine efficiency in case of two stroke engine?
Why different types of sound are produced in different bikes though they are run on Si engine
What stands for ac in ac mechanical fuel pump?
The main function of transmission is a) To provide means to vary the torque ratio between the engine and the road wheels b) To provide neutral position c) To provide means to back the car d) all of the above
What are three methods of heat transfer?
What is back compressor in engines?
Why are i/p transducer connected with 24v dc not to 220v ac?
What is the basic difference between honing and boring.
