Answer Posted / senthil kumar
EDO - Electrical Draw Out
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
The loads are connected with phase and ground then why current flow as the loads ?
Why the output of OP-AMP is always less than Vcc?
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
What is a copper loss or i2r loss pc?
Sir, I m 3rd year student 4m DCE and want to do internship in siemens or l&t or any other mnc related to electrical engineering. please tell me the procedure 4 same and oblige me
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
Motor,transformers,capacitor tubelight etc....
Is it advantages of having star-delta vfd than normal star vfd , if yes why?
SUTIABLE FOR ohm's law super conductor
how to failure indution motor insulation & how to improve heat in motor insulation
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?
Please elaborate th´evenin’s theorem?
