Interested to Buy Any Domain ? << Click Here >> for more details...
What will be the change in its efficiency and other
parameters of a ONAN transformer if it changed to ONAF
transformer ?
- 3 Answers
- 5436 Views
- Tesla, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
You can increase the capacity the transformer.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How we select the vector group of 3phase power transformer?
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
earth also having a gravitational force (magnetic field of north and south)but it attracts any object compare to this theartifical magnetic cant perform same as earth why?
can we synchronize star system generators with delta system transmission line ? and how ?
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
ACB & VCB how do work and saftes and how can maintenance in this and parts name show with picture
Which power will flow first if we switch on a motor Active or Reactive? How?
what is load despatching
Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?
What kind of maintenance is conducted for Transformer
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
How to design harmonic filter at the project stage without nowing the harmonics levels
why dimmerstate always connected in star connection? what will happen if it connected in delta?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
How does HT work & Voltage required?
