Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference b/w single and three phase circuits?
- 1 Answers
- 5170 Views
- I also Faced
- E-Mail Answers
Answer Posted / power team
* Power Consumption is less in case of Three Phase Circuit
(P= sqrt of 3 * Vph * Iph * PF)where as in single phase
circuit,power consumption is more(P= Vp * Ip *PF)
* Efficiency is much better in 3Ph circuit than 1Ph circuit
* Cost of transmission is high in 3Ph circuit
* Voltage regulation is better in 1Ph
* 3Ph circuits are widely used by Industrial HT consumers
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
can we make a electric generator,which can not use any type of fuel,air,solar,gas,thermal,coal,petrol,etc and able to produce electrical energy (or self electricity generating generator)
How to know th details about an electrical Drawing ? Please mention the easy method.
Which thing is maximum in RLC circuit at resonance a)power consumption b)inductive current c)capacitive voltage
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
What is meant by bus bar protection?
In a synchronous motor. if start is running at high speed. What will be the starting torque : Higher Lower Zero
What is core CT & it's function?
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
Pls Breifly explain about UPS (Inverter,Reserve,Rectifier,Float voltage,Boost voltage).
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
what does a k rating in a transformer means?
Electrical Engineering
what is advertised hop count
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
