Interested to Buy Any Domain ? << Click Here >> for more details...
what will be the neutral to earth voltage while checking by
the Digital multimete? and why?
- 1 Answers
- 3647 Views
- I also Faced
- E-Mail Answers
Answer Posted / harshu
If we measure the vtg between neutral and ground, there may be a trace of "stray voltage"..that is, vtg in the neutral..its the product of current thr. Neutral(which is part of that circuit itself) and the impedence of that neutral wire.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
WHAT ARE THE CHARACTERISTICS OF AN VOLTAG AMPLIFIER
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is the thumb rule for determination resistance of resistor?
What will be result if we connect LT votage to the terminal of HT motor?
Best way to measure the Soil resistance of rocky soil, three probe method and four probe method
What is the formula for calculating no-load current?
What is shutdown of electrical sub station?
What is precision of a measurement?
How to reduce the static electricity producing in solvent room? By P.D.Patil BioCon
when ID fan will immediately stop through VFD what exactly cause and problem the ID fan
can u give me a brief idea about power line carrier communication ??
How many capacitors using in LT panel as per Govt rules?
why capacitance effect is predominant in underground cable transmission and inductance effect is predominant in over head line transmission?
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
why dc is used in control circuit for mv & hv switchgear instead of ac
