How power factor affect on bill explain with example.
Answer Posted / deepthi
cosine of angle between voltage and current..is also said to
be power factor..
decrease in power factor leads to increase in the
electricity bill..so therefore the loads having almost
nearer powerfactor to unity are more advantageous..
Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Is Transol transformer oil comparable to nynas nytro libra?
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
What is the role of feedback in a closed loop control system?
What is the maximum operating temperature for a thermoplastic insulated cable?
what is servo motor and how to work it.
What is load boxes ?
Classify milling machines.
Differentiate between low pass, high pass and band pass filter?
How to work meggar?
How would you relate your key competencies to this position?
which is better to use svc or synchronous condenser why ?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
how to produsing geretor power
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
What is the diff. between single compression and double compression gland