Interested to Buy Any Domain ? << Click Here >> for more details...
why transformer ratings are taken in 11kv 22kv 33kv but
not in 10,20,30kv
- 5 Answers
- 12110 Views
- ushacomm, I also Faced
- E-Mail Answers
Answer Posted / akshay
becoz generated EMF=4.44f*N*flux Volts, so the vale of
NFand fluz will be multiply by 4.44 so its look like in the
form of 11,22,33 etc
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
i have 3500 amp load and select current transformer and perches.how i calculate .please understand
Can anyone tell me some hints about what type of questions are asked by the interviewer by an Electronics engineer when company is installing an IPP and wants a team of engineers?
For a stable system, where should the poles of a system be in a root loci plot?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Define active and passive network?
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
upto how many load can v connect to stabilizer which is used for tv
what are the basic insulation levels & what its Unit
what is metering cum synchronizing panel and how it is used?
why swinburnes test cannot be performed on series machines?explain
How the PF control while running DG set with load
how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?
What is the phase relationship between the primary and secondary voltages of a transformer?
How will you define capacitance?
I have motor 1500 HP and , 4160 V , 60 HZ , then i need the rating of transformer which can feed that motor ??
