What is the working of AVR in AC generators?
Answer Posted / joginder singh
AVR is automatic voltage ragurator,there is diffrent type
of exitation on depend the load.and set the trminal volts,
Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
why electron produce magnetic field when it is in motion?
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
how to Select its CORE in electrical cables based on its applications? or Application of various types of electrical cable based on it CORE?
How to decide the size of the capacitor for a single phase induction motor say 2 HP ??
An automatic water heater is an example of which type of control system?
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
What is the use of oil in transformers?
How to calculate the sag on transmission Lines.
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
what r substations?what r there work?why voltages r incresed and then reduced during distribution of power