Hai I have 2500KVA,Transformer,13.8KV/380.DELTA/STAR.How
much load that I can take interms of current?How can I
calculate also when I have loads in KW?
Answer Posted / k.murugesan - tamil nadu
In Delta Connection
Line Voltage VL = Phase Voltage VP But Line Current IL =
1.73205 times of Phase Current IP.
In Star Connection
Line Voltage VL = 1.73205 times of Phase Voltage VP But Line
Current IL = Phase Current IP.
Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
how is find out kwh step by step
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
what is vA rating and class of a ct.
what is the ms flat constant for calculating earth mat design calculation?
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
How many types of faults are there in 3 phase power system?
physical identification of HT & LT panel
How does a tertiary winding filter harmonic(espcially 3rd one) from entering into load system?
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
Write down the name of 2 lady Bir Pratin of Bangladesh
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?