which trsanmission is easy and cost effective AC or DC.
- 19 Answers
- 16604 Views
- I also Faced
- E-Mail Answers
Answer Posted / rakesh
in case of overhead lines AC is economical for distance less than 700km.for greater than 700km DC is economical
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why HT armoured cable does not glanding
how to measure earth resistance of a substation
hi if anybody got model questions for cpcl Grade'A' electrical engineer position.send it to my mail please krishkumar22@gmail.com
What is step signal?
what is a bus riser in power system and why it is used
What is time invariant system?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
Give details of your interested designation, the post you are interested to serve the company better and explain why you think you can serve the company better in such position if employed?
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
On a 3 winding transformer YNynd11, how do you apply REF protection to the Delta tertiary winding that is supplying auxiliaries to a substation?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
what is the difference between the characteristics of two different phase bushing of any transformer
Incoming line 11kv And transformer capacity is 2500kva. Consumption load is 1300A. Then fuse capacity is 11kv line.
how we can calculate 2 phase welding transformer rating or total power?
