Interested to Buy Any Domain ? << Click Here >> for more details...
Why generally the transformer primary is connected in star
& secondary in delta
- 7 Answers
- 18798 Views
- I also Faced
- E-Mail Answers
Answer Posted / raul
its absolutely wrong dat most of d times the primary is
star connected and sec is delta connected...........the
connections depends upon d type of service
required........i.e star-delta is used as step down
transformer, delta-star as step up transformer.........star-
star is rarely used until required due to disturbance
caused in d neighbouring communication system .......
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
High speed earth switch operation with diagram
best manufacturer for busbar for outdoor switchyard having double bus bar scheme, can any one share technical specification of busbar. 132kv voltage ?
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
Where servomechanism is used?
Why PS class CT is always preferred for Differential protection?
What is 100% protection of generator? Why 100% is not used but 95% is generally used?
i need the details about bhel exam.how to apply for that.please send to my email-id.thenmozhi2k7@gmail.com
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
what is the reason the main breaker is trip during the motor is running? (some time the breaker is not trip)
how can decide the current rating of oltc
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
diff. between tension mode & speed mode
How each of the following losses occur in d.c machines (i) copper (2)core (3) windage (4)friction please help me
