Interested to Buy Any Domain ? << Click Here >> for more details...
why does not tester light up when it is touched to neutral of
3 pin socket.
- 4 Answers
- 20212 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
I gave the wrong answer as the word 'not' escaped my
notice..The tester requires at least 40-60 volts to light
up depending upon the series resistor used.As neutral is at
almost zero potential from ground ,tester does not light up.
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
what is integrated ac contact circuit
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
1. transformer design formula ? 2. how to calculate the primary turns and secondry turns ? 3. core types ? 4. how to find the primary current and secondry current ? 5. how to calculate the stacking factor ? 6. range of fulx density ?
Difference between rating factor of cable and derating factor of cable?
Difference between transition and diffusion capacitance
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
what is meant by power and distribution transformer ?
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
What is the method of estamating of cable, CB,MCB ?
Define what is power quality meter ?
delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
WHAT IS MEANT BY DERATING OF THYRISTOR?
what is the id1 & id2 setting in differential protection relay of CSPC?
What are the advantages and disadvantages of the ac motors?
