why does not tester light up when it is touched to neutral of
3 pin socket.
Answer Posted / k.prakashchandra
A loose joint in the neutral wire
Is This Answer Correct ? | 2 Yes | 16 No |
Post New Answer View All Answers
how we arrange the hv side with delta connection in case 33/11kv of transformer.
what parameters should we check to reduce the power bill
please give me all the Alarm .Trip ,Safety Relays & Conditions of UPS Systems mail me on ashokbabunhce@gmail.com
how open delta PT works & what is its construction?
what is the transformer turn ratio formula and give some examples?
what is cogging and crawling
What is the fault or needs to be done when frequency in ac drives is not changing?
What's the difference between non break power supply and non break non short break power supply
what is JE exam?
why we r not earthed Control cable of C.T. terminals
Transformer diagram mention each parts ?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
what is the difference between an alternator and a synchronous motor
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
what kn of disc is used in 33kv,132kv,220kv,400kv,800kv transmission line