i want to Measure the Difference pressure of Packed distillation Column of height 3 mtr. h.p. side connected to
bottom & L.P. side connected to the top , so tell me what
will be THE URV & LRV of that D.P. transmitter?
Answer Posted / rajkumar
The height of column doesn't
matters here. You have to fix
the range in approximate
estimation of maxim pressure
drop. For example the
heighest d. pressure will be
the equal to inlet pressure.
So you can set this also a
range.
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Explain why plc require in analog input 4-20amp & 0-10 volt?
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
Positioner usage.
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
What are different types of cable?
Specify for Cables - Flame Retardant and Fire Resistant?
What is the minimum rating availalbe for weld neck orifice in market?
What is 3 selection available when configure the burnout protection for controller
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
Differentiate between ultrasonic flowmeter and radar type flow meter
Whatis the reset ofset and control system in instrumentation
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
What is 3 element control system