Interested to Buy Any Domain ? << Click Here >> for more details...
1.After synchronising the alternator to the grid,how we r
delivering power to the grid?if the i/p increases does the
speed hence frequency increases?
2.y the power factor is changing when exitation changes?what
is the relation with p.f and flux?
- 4 Answers
- 10685 Views
- BSNL, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
If you want to increase the speed more input to prime mover
is required.As the grid is very large ,this will result only
in more sharing of load.You can not change the frequency.If
you increase the excitation, the terminal voltage of gen
will increase ,and you can not increase the entire grid
voltage . This additional voltage will drop in the gen
itself and a small portion of grid ,resulting in more gen
current and increased lagging pf.If the terminal voltage of
the gen is less than grid voltage the power will be
evacuated at leading pf and again more gen current.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Is electro plating what type of load whether resistive, inductive or capacitive loads
how calculate the electrical load for industry and office
What is Meter MF if External CT Ratio is 150/1 , PT Ratio is 132/110 Meter CT Ratio is 200/1 & Meter PT Ratio is 110/1
What is the actual calculation for transformer short circuit test?.
what sort of general awareness questions are asked in o.n.g.c entrance exam?????????????????
What is T’Q and X’Q and X’D ? and what is saturated as well as unsaturated ?
how to select overload-relay for perticular motor 1.for D.O.L. starter 2. for Star-delta starter ????
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
WHAT IS DEGREE OF COMPOUNDING IN D.C MACHINE MEANS? HOW TO READ THE OPERATING CHART FOR ANY ELECTRICAL MACHINES?
a governer in an Ic engine controls the
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
sugest any typical project ?
Is vtg is controlled by the resistor? if else how much?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
What is the fault or needs to be done when frequency in ac drives is not changing?
