Interested to Buy Any Domain ? << Click Here >> for more details...
The wire is disconnected from the fuel gauge sending unit
(bimetallic gauge). A voltmeter connected to the wire reads
a pulsating 5v. What does this indicate?
- 3 Answers
- 6964 Views
- I also Faced
- E-Mail Answers
Answer Posted / rawjaw
Hello ogagandeep.. Can we
say that it indicates ckt open?
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
what is interface level and how it is calibrate?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
Explain types of valves?
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
if my flow is 20000 m3/h than which range of DPT i have to use????
what is the protection system in solar turbine compressor
hello can yoy pls send me previous papers of jindalpower and steel ltd.....'m from instrumentation..... mani1048@gmail.com
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
what is exact time to study dcs and plc cources
