Interested to Buy Any Domain ? << Click Here >> for more details...
Why power factor should not be in leading (capacitive) mode
of any load.
- 3 Answers
- 7133 Views
- GE, I also Faced
- E-Mail Answers
Answer Posted / karthick
due to lead of power factor it causes the voltage to increase
hence, lows the value of current ,,, due to high voltage it
causes the equipment to damage
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What is the count of hvdc transmission lines in india?
Why is better to have a minimum ceiling voltage of 250% than 160%?
wht is embedded systems? what is new inthis field?
What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
what is cause of static electricity? I experience shock when i touch metal equipment in a room ,furher check shows earth leakage showing 80ma at the DB near to the 400 MCCB?
can anyone give an idea about dia calculation in cold rolling mill
can we start slipring motor on star delta like we start induction motor ? if yes where will we connect ?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
What will happen if the d.c. Shunt motor opened accidentally running on no-load has its shunt field winding?
I need the list of Universities who have summer intake for BS degree in Electrical Engineering.?
EXPLAIN THE TRANSFORMER MAINTENANCE?
What are the material used for resistor?
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
How does a battary stores charge in it? please explain in simple manner and in detail.thanks
