Interested to Buy Any Domain ? << Click Here >> for more details...
Why power factor should not be in leading (capacitive) mode
of any load.
- 3 Answers
- 6973 Views
- GE, I also Faced
- E-Mail Answers
Answer Posted / mayuri baradkar
actually the power facter should be leading. because of
leading power factor kva capacity will increase. this will
reduces the power consumsion.so we have to preffer the
capacitor bank in any industrial areas.which will not lagg
the power factor.
| Is This Answer Correct ? | 1 Yes | 12 No |
Post New Answer View All Answers
What is power relay?
what rectifiers is and what are the types of rectifiers?
Why synchronous motor is used in power factor improvement,dc series in lift
what is the basic need of domestic loads 1- voltage 2- current
i want bhel placement paper for electrical if anybody having pl send to my id kavitha867@myway.com immediately
what do you mean by class PS CT and what are technical details needed for calculating it?
why we use copper earthing for neutral while for body GI.
What is the ratio of Booster transformer?
how can we design robots
what is effect of leading power facter on the system and billing
if you are in a software company,then why do you want to come in a core company like sail, ntpc(where lots of trouble like tension but you have a good life in a it company) ?
what will happen if there is a voltage leakage or current leakage in an electrical train
how many synchronous motor are there in any power plant
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
What is difference between Over Current & Earth Fault protection?
