how to choose the cable size for 100A(is there any formula
please update)
Answer Posted / k.prakashchandra
In usual practice, the carrying capacity of copper is taken
as 2.5 A/sq mm and 1.5 for Al.If the load is steady and
continuous 60 % of these values are adopted.
Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
300m long and 30kw inductive loade 3phase supply how many size cable required
what is KA rating and how can we choose switchgears on applications
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
how do i work out the Amps of a incommer if i am running 1 37 KW motor and a 0,75 KW motor and some solinoids
can i able to get bhel previous exam question paper?
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
lorteny method
by using pump duty, how we will can calculate the motor duty(KW)? is there any standard or formula.
what is the interrelation between voltage current torgue speed and magnetic flux in case of different types of electric motors
What are the main advantages of bode plot?
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
how was your last weekend.
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.